*本博客文章介绍了一些优等产品。
您需要的东西:
- 凿
- 锤子
- 扁木钻头
- 门锁
- 回扣套件
- 门把手
步骤1–标记手柄的高度
第2步–凿出回扣在门
第三步–在闩锁上钻孔
第四步–闩锁正面周围的凿子
第5步–标记罢工板的位置
第6步–打击板凿唇
Just like the latch, the strike plate must also be installed dead centre in the side of the door. 一旦您’ve drawn up where this will go, you can go ahead and chisel along the 唇 for the strike plate to slot into.
我们发现这边很难凿。部分是因为我们’d annoying located it over a knot (eurgh!) and also because the amount we had to chisel would only leave about a 2mm bit of wood on the 唇. It was tense, let’s just say.
一旦我们’d chiselled enough of the 唇 out, we then chiselled another couple of millimetres for the rest of the plate to recess into (just like we did on the other side!). We also chiselled out the centre part where the latch will catch on the plate. Like this:
步骤7–手柄钻孔
因此,困难的部分已经结束!现在您需要做的就是找出需要在门把手上钻孔的位置。我们卸下了闩锁以进行标记,然后用合适的钻头在门上直接钻孔。然后,您可以插入心轴(如果需要,可以切成一定尺寸!),然后将手柄直接拧到门上。
步骤8– Enjoy!
本文中使用的一些工具和材料:
发表评论